InnoFlue® Flex
Chimneys and chases with multiple offsets can make any venting job a virtual nightmare. Not anymore! InnoFlue’s® Flexible venting option allows for multiple offsets which traditional single wall pipes cannot overcome. We can custom cut any length necessary for your particular venting application. We have diameters of 2, 3 and 4 inch available in our flex line and have multiple length kits available.
Vertical installation/termination through a masonry chimney/chase
A base support and spacers support and secure the flexible pipe within the chase. Installation can either be lowered down through the top of the chimney, or pulled through the opening at the base. Multiple flex liners can be installed in the same chase by bundling the liners together and lowering them down to the base of the chase.
Chimney with offsets
Typical InnoFlue® Flex chimney installation with one or more offsets.
Straight chimney termination
Typical InnoFlue® Flex chimney installation with no offsets.
Through the roof termination with offsets
Typical InnoFlue® Flex chimney installation terminating through the roof.
Note: InnoFlue® Flex cannot be installed horizontally. Individual offsets can not exceed 45°. It is recommended that InnoFlue® Flex be installed from the bottom of the chimney/chase and pulled up to the top. Do not store InnoFlue® Flex liner at temperatures below 40° F.
Vertical Installation/Termination into an existing B-Vent
When venting through an existing b-vent, use the same principal guidelines as you would a chimney or chase. Our b-vent covers span multiple diameters to cap off virtually any b-vent.
Termination through an existing B-Vent
Typical InnoFlue® Flex chimney installation through an existing B-vent.